Frequently Asked Questions On LamanatorPlus
How much of a shine will it put on the laminate floor?
A. Each coat that you apply will raise the shine by a 30% gloss level. If your floor is dull, then it will look like more of a satin like finish with the first coat. By applying a second coat, you will achieve a beautiful shine.
A. To remove this product, use Laminate Fresh Start and a mild abrasive scrub pad. This process may have to be repeated to completely remove the Lamanator Restorer. However, if you are going to re-apply the Restoration product, there is no need to completely remove the original application of Restoration as it will blend.
A. It is a 20% solid thermal plastic polymer.
A. It helps hide scuffs, scratches and stops tracking. It also helps seal (coat) the joints and helps prevent peeling.
A. Yes, the LamanatorPlus System is excellent to use on a new laminate floor. The LamanatorPlus Fresh Start will remove the factory overspray that is on all new floors. This oily & sticky residue attracts dirt causing your floors to not only look bad, but also makes them very difficult to maintain. Our LamanatorPlus restoration product coats the joints between the floor boards, which helps prevents water from seeping in and causing the joints to peak. Our products also make cleaning easier and will brighten up the colors in the wood.
A. Normally, we would recommend a minimum of one year between applications, depending on the amount of traffic to the area. It could very well be longer before another application is needed!
A. Yes, the restore and maintenance cleaner products can also be used on pre-finished hardwood, bamboo and cork floors. The Fresh Start stripper can be used on other floors to remove unwanted substances or to remove the LamanatorPlus Restoration product if desired.
A. Yes, this product works great on laminate and wooden countertops. Simply apply it just as you would to the floor.
A. Yes, it will make the sheen level the same when one box is different from the other. There has been a lot of this problem, but LamanatorPlus will take care of it.
A. It is very easy to apply, unlike urethanes, etc. Everything is done using a spray bottle. First you spray the floor with Fresh Start and allow it to sit for 3 minutes. Then agitate with the scrub pad that is in the two in one mop package. After mildly agitating, you switch to the micro fiber mop...this is an important part. Get the floor cleaned well enough that your pail of water turns clear from the final rinse. Then when you use the Restoration, it will not only adhere perfectly to the floor, but your floor will also be so clean and beautiful that it will shock your eyes. Then use the micro fiber mop and the Restoration product. Mist product on the mop first and then on the floor. Spread evenly and allow it to dry for 20-30 minutes. Apply second coat, and presto, you are done! Maintain your floors from this point using LamanatorPlus Floor Cleaner.
A. No, LamanatorPlus will not change the traction of the floor once it is fully cured (about 12 hours).
A. Yes, LamanatorPlus will remove wax from laminate floors. If the wax has been used repeatedly on the floor it may be necessary to clean the floor twice with the Fresh Start, however, this is usually not necessary.
Have a question not listed here. Simply fill out the form below with your question in the message box, and we will get back with you promptly.
OR BY PHONE: